Amana ATX 518 VW Service Manual page 53

Ice Maker Troubleshooting Chart
II. OVER PRODUCTION OF ICE
1. Bail Shut-off Arm Not in Actuator
2. Misformed Bail Shut-off Arm
3. Shut-Off Lever Broken or Bypassing Vertical Cam
4. Broken Module Actuator
III. HOLLOW ICE CUBES
1. Water Fill Volume Too Low
2. Improper Freezer Air-Flow
3. Thermostat Out Of Calibration
IV. FLOODING OR ICE SLABS IN BUCKET OR FREEZER
1. Thermostat Out Of Calibration
2. Jammed Cube Stalled In Water-Fill Cycle
3. Leaky Water Valve
4. Fill Volume of Water Valve Excessive
5. Motor Stalled In Water-Fill Cycle (12:00 Ejector
Position)
6. Contaminated Module
7. Refrigerator or Ice Maker Not Level
8. Excessive Water Pressure
9. Module Shut-Off Switch and Contacts Shorted And
Burned
10. Broken Locking Tab On Verticle Cam (Stalled in
Waterfill)
11. Fill-Tube Not Properly Located In Fill Cup
12. Fill Cup Water Opening Flashed Over/Plugged
13. Cubes Fell Over Back Of Ice Maker, Melting Into
Freezer
1. Replace Bail Shut-off Arm in Actuator, Note for
Loose Fit
2. Replace Bail Shut-off Arm
3. Replace Ice Maker Module
4. Replace Ice Maker Module
1. Adj. Screw On Module, Clear Water Path Or Change
Water Valve
2. Re-Direct Air Flow Away from Ice Maker Thermostat
3. Change Thermostat, Apply Fresh Alumilastic
1. Change Thermostat, Apply Fresh Alumilastic
2. Remove Cube, Determine Reason For Stall
3. Change Water Valve
4. Change Water Valve
5. Change Ice Maker Module
6. Change Ice Maker Module
7. Level As Necessary
8. Lower Water Pressure (20-120 psi) (1.4 - 8.2 bar)
9. Change Ice Maker Module
10 Change Ice Maker Module
11 Reposition Fill Tube
12 Change Fill Cup
13 Install New Fill Cup
53 RS5280001 Rev. 0