Set Luminance Offset; Function Setup; Configure Function - Sony Screen Management System User Manual

Set Luminance Offset

During installation of the SMS the Lamp Power is adjusted
to provide the desired screen illumination. This value can
be set in a FUNCTION as the calibrated lamp brightness
for an associated aspect ratio.
On occasion, it is desirable to increase the screen
luminance, i.e., raise lamp brightness, to meet special
presentation needs. The Luminance Offset slider allows
you to make this temporary (offset) adjustment.
Luminance Offset
Control
Lower RESET
Note
The Luminance Offset will remain in effect until you tap
RESET which returns the offset to "0" (zero).
Luminance Offset (Adjust)
The Luminance Offset control is a slider which allows you
to make temporary adjustments to increase or decrease the
screen luminance value within the predefined limits of
Lamp Power for the bulb.
To adjust the Luminance Offset, tap Menu, tap Projector,
tap Projector Control and then either touch and drag the
Luminance Offset control or press and hold the Plus
or Minus buttons until the desired screen luminance
(image brightness) is obtained.
Note
While adjusting Luminance Offset affects lamp
brightness, the Lamp Power indicated on the FUNCTION
SETUP screen is not changed.
Luminance Offset RESET
To return the screen luminance to the value stored in the
currently selected FUNCTION, tap Menu, tap Projector,
tap Projector Control and then tap RESET located below
the Luminance Offset slider.

Function Setup

To ease the projector setup task the SRX-R320 Projectors
allow you to save specific configuration settings under
twenty selectable FUNCTIONs (F1 through F20). The
majority of the projector settings must be configured and
saved to a FUNCTION using the SRX Controller
application. However, some settings may require
adjustment of a more immediate nature. These are
available to you on the FUNCTION SETUP screen.
Note
Controls in the ADJUST PROJECTOR group are
unavailable when the Projection Type is set to "Single
3D".
A limited number of
adjustments are available
on the FUNCTION
SET-UP pane. To access
Function Setups, tap
Menu, tap Projector and
then tap Function Setup.
Value Raise
The FUNCTION
SET-UP pane appears.
Caution
Any changes made to
adjustments on the
FUNCTION SET-UP
pane change the
presentation as soon as
the adjustment is made.
However, unless "Saved" prior to leaving the
FUNCTION SETUP screen the changes will not be
present the next time the same FUNCTION is selected.
Changes which are Saved to the FUNCTION will be
reflected in the settings returned the next time the indicated
FUNCTION is selected on the Projector Control panel or
recalled when an SPL includes a CPL associated with the
FUNCTION.
From the FUNCTION SETUP screen you can set LAMP
POWER and adjust image related settings (ADJUST
PROJECTOR). The settings are stored for later recall
using the indicated FUNCTION (Current Function).

Configure Function

From the FUNCTION SET-UP pane you adjust selected
functions and can save the changed values to the Current
Function (refer to "Change Projector Function" on page
42).
Tap Function Setup
1.The SRX Controller exercises direct control over the
projector and therefore should not be used at the same time
the Projectionist Terminal or SMS Controller is in
operation.
1
Projector Menu
43
Projector