Projector; Projector Control - Sony Screen Management System User Manual

Projector

Basic control of selected Projector system functions are
available from the Projectionist Terminal. In the
SRX-R320 based system, reference to the "Projector"
includes only the projector portion of the Auditorium Unit.
When the Projector is in STANDBY various subsystems
of the auditorium unit are still operational. To Shutdown
the Auditorium Unit refer to "Restart SMS Server" on
page 69.
Note
When the Projector is in STANDBY mode the system
remains active and accessible via either the Projectionist
Terminal or the SMS Controller application. When the
Auditorium Unit has been Shutdown you must execute a
Power ON sequence which is described in "Restart SMS
Server" on page 69.
The Projector menu
selection allows you to
access information and
control functions for the
following items.

• Projector Control

• Function Setup
• Projection Type
• Adjustment
• Ghostbuster
• Remote Update
To access Projector
menus, tap Menu and
then tap Projector. The
Projector Menus
appear.
From PROJECTOR CONTROL you can place the
Projector system in STANDBY, return it to ON
(operational mode), turn off the LAMP, DOUSE the image
output, recall a preset configuration, and adjust the
Luminance Offset applied to the current presentation from
the Digital Cinema projection system.
From FUNCTION SETUP you can modify a limited
number of projector settings; Lamp Power, Zoom, Focus
and Electrical V Shift, and save these new settings to the
Current Function.
From Projection Type you designate whether the projector
is configure for 2D or 3D presentation.
From Adjustments you perform projector alignment
operations.
From Ghostbuster, you can check whether the Ghostbuster
function is ON/OFF.
40
Projector
Tap Menu
Tap Projector
Projector Menu
Projector Control
The PROJECTOR
Tap Projector Control
CONTROL pane
contains basic controls in
addition to Current
Function select and the
Luminance Offset
control. To access
Projector Controls, tap
Menu, tap Projector and
then tap Projector
Control. The
PROJECTOR
CONTROL pane
appears.
Note
Changes made on the
PROJECTOR CONTROL pane effects as soon as the
selection is made.
Caution
DO NOT REMOVE AC-MAINS POWER TO SHUT
DOWN THE SYSTEM OR SET THE PROJECTOR
BREAKER TO OFF AS LAMP COOLING WILL BE
LOST AND THE RISK OF LAMP FAILURE IS
INCREASED.
STANDBY
POWER Group
3D Function
LAMP OFF
The following table provides a guide to the possible
Projector State/State transition possibilities.
Current Mode Transition
STANDBY OK
NO
ON OK
OK
LAMP OFF OK
OK
Projector Menu
(Projector) ON
(Lamp) ON
LAMP ON
New Mode
ON
LAMP OFF
STANDBY
LAMP OFF
STANDBY
ON