Sony Screen Management System User Manual page 21

To add a Start Offset to the Playlist, tap Content, tap either
the Scroll Up or Scroll Down
locate Black, tap Black to select, and then tap Add. The
ENTER GAP DURATION popup appears.
Seconds
Minutes
Hours
Accept
The duration of the Start Offset (virtual Black Leader) is
set using the ENTER GAP DURATION popup. This
duration is an absolute value and adjusts the start time of
the following Playlist Element in relation to the end time
of the preceding Playlist Element. To enter a value, tap the
target, i.e., Hours, Minutes, or Seconds, and then tap (or
touch-and-hold) either the Plus or Minus to
increment/decrement the value of the selected target.
When the desired value is reached, tap Accept. The
ENTER GAP DURATION popup closes and the added
Black appears in the right-hand list at the end of existing
Playlist Elements.
Position the Start Offset to the correct position
within the existing Playlist Elements. To
move the Start Offset (Black Playlist Element), in the right
side list tap the Black to select and then tap Down or Up
(control illustrated to the right) to move the Start Offset
one event position in the desired direction. Continue to tap
Down or Up until the Start Offset is in the desired position
in the Playlist. The start time of following Playlist
Elements are delayed to accommodate the duration of the
Start Offset.
To add Black which is actual Content, locate the Content
and add it to the Playlist in the same manner as you would
add other Content. (See "Add Content" on page 21.)
When all changes are complete, tap Save. CREATE
PLAYLIST closes and you are returned to the MANAGE
SHOWS pane.
Add Content
To add Content to the New Playlist, tap Content (left-side
list) to display available Composition Playlists. Tap either
the Scroll Up or Scroll Down
locate the Content of interest, tap the Content Title to
select, and then tap Add. The added Content appears as a
Playlist Element at the end of the Playlist.
arrow until you
Close
Minus
Plus
Cancel
arrow until you
Note
3D Content is identified in purple. When 3D Content is
added to an SPL the PLaylist Title is shown as purple in the
list of Playlists.
When Playlist Elements already exist you may need to
reposition the newly added Content to a different location
in the Playlist timeline.
To move the newly added Playlist Element, in
the Playlist tap the Title (select) and then tap
Down or Up (illustrated to the right) to move the selected
Playlist Element one event position in the desired
direction. Continue to tap Down or Up until the selected
Playlist Element is in the desired position in the Playlist.
When all changes are complete, tap Save. CREATE
PLAYLIST closes and you are returned to the MANAGE
SHOWS pane.
Note
Be sure to tap Save before leaving this screen. If you close
the screen without tapping Save, all changes will be lost.
Add Command
Playlist Command Elements can be identified as a 3D
related Command at the time they are created and are
indicated by a "[3D]" designation shown in purple. This
"3D" designation is retained when the Command Element
appears in the Playlist.
Note
If a 3D Command Element is added to a Playlist the
Playlist is identified as a 3D playlist and appears in purple.
Command timing is related to the absolute time of
execution from the beginning of the Show Playlist. During
the process of adding a Command, an Offset popup will
open where you can set the appropriate value. To add
Command(s) to the current Playlist, tap Command to
display the available Automation Controls, e.g., curtain,
lights, etc., and Auditorium Unit Commands, e.g., Douser.
Tap either the Scroll Up
until you locate the Command of interest, tap the
Command to select, and then tap Add. The ENTER
OFFSET popup appears.
Seconds
Minutes
Hours
Accept
or Scroll Down arrow
Close
Minus
Plus
Cancel
Shows
21