Care And Maintenance; Cleaning The Housing; Metal Grease Filters - V-ZUG DFN 6 Operating Instructions Manual

5

Care and maintenance

5.1

Cleaning the housing

Take care that no water gets into the housing of the appliance! If wa-
ter gets into the housing, it can cause damage.
Do not use abrasive cleaners, scouring pads, steel wool, etc. for
cleaning, as they can damage the surface. Disconnect the appliance
from the mains and unscrew the fuse or switch off the automatic cir-
cuit breaker.
Cleaning the outside/inside
▸ Clean the outside of the appliance with a warm, damp cloth and a little de-
tergent and then wipe dry.
– Grease and condensate water can build up on the inside around the

metal grease filters.

▸ Clean with a warm, damp cloth and a little detergent – you can also use a
brush if necessary – and then wipe dry with a kitchen towel.
5.2 Metal grease filters
The metal grease filters must be cleaned at least once a month with normal
use. If properly cared for, the grease filters should provide years of service.
Removing
Do not damage the metal grease filters.
▸ Pull the deflector plate 1 com-
pletely out.
▸ Push the grip 2 on the grease fil-
ter in.
– This releases the grease fil-
ter 3.
▸ Carefully pull the grease filter 3
down and out of the fixture.
▸ Clean the grease filter 3.
2
1 3
15