Table of Contents
Advertisement
15
Manual cutting control
.07.05
Rule
Two threads must be cut cleanly on both the left and right in the thread catcher cutout 1.
Fig. 15 - 24
O Manually move the thread catcher 1 to its front turning point.
O Pull a double-up length of thread and hook it in the thread catcher cutout.
O Carry out the cutting operation manually.
O If the threads are not cut according to the rule, align the thread catcher 1 (screws 2) to
the knife 3 accordingly.
O Move the stop 4 until it abuts the thread catcher 1 and tighten the screws 5.
O Chapter 15.07.02 Aligning thread catcher laterally, check and adjust if necessary.
3
1
1
2
5
4
Adjustment
31
Advertisement
Table of Contents
