Hole
Joint
Figure 2-22 Remove the Metal Ring and the Bubble
2.
Adjust the horizontal position and the vertical direction for each
camera.
Figure 2-23 Adjust the Surveillance Angle
3.
Install the bubble, metal ring, and cover back, and fix the cover.
Note:
The side of the metal ring marked with TOP should face
upwards, and tighten the four screws to fix the metal ring.
2.5 Installing Type V Camera
Installation for Type V camera is similar to installation for Type VI
camera. Refer to section 2.4 Installing Type IV Camera.
Network PTZ Camera·Quick Start Guide
Metal Ring
Camera
21
Bubble