Table of Contents
Advertisement
SERVICING VERTICAL LIGHTING
Refer to door manufacturer's manual for servicing of vertical lamps.
SERVICING DOORS AND FRAMES
See door manufacturer's service manual for servicing information. One
manual is shipped with each merchandiser.
Hussmann's Innovator Door manual (P/N 0425683) can be found on the
Hussmann website www.hussmann.com.
REPLACING DOOR OR DOOR FRAME PARTS
Parts for Reach-in doors and door frame assemblies must be ordered
direct from the door manufacturer This includes the glass doors, door
frame assemblies, lamps, ballasts, door handles, hold open slides, and
power cords.
Refer to specific warranty supplied with the door. The manufacturers
have a warranty against moisture penetration, a warranty against
tempered glass breakage, and a warranty on ballasts. Lamps are not
covered by Hussmann or the door manufacturer.
HUSSMANN CORPORATION • U.S. & CANADA 1-800-922-1919 • BRIDGETON, MO 63044-2483 • MEXICO 1-800-890-2900 • WWW.HUSSMANN.COM • PN 3053328_H
REPLACING DAMAGED DRAIN FITTING
The following procedure is for the field repair of a broken drain fitting.
1. Use a drill with a 1 7/8-inch (48 mm) hole saw to drill out the
bottom of the drain fitting. Be sure to drill completely through fitting
and bottom liner.
Drain Fitting viewed from Inside Case
Viewed from Inside Merchandiser
2. Insert adapter into drain fitting. Do NOT use thread sealer on ABS
drain fitting. If sealer is used the ABS drain fitting may crack or leak!
(Tee should be tightened no more than 4 turns.) Do not overtighten
threads.
Foam Bottom
Assembly
Modified Drain
Fitting
Do NOT use Thread Sealer on Drain Fitting!
Do NOT use Thread Sealer on Drain Fitting
6-4
Drain Fitting
PVC Adapter
1
/
x 1
/
in.
1
1
2
4
(38 x 32 mm)
(obtained at local
building supply store)
Tee
1
/
in. TxSxS
1
4
(32 mm)
End Section View
Advertisement
Table of Contents
