Wap6906 Access And Login - ZyXEL Communications WAP6906 User Manual

11.2 WAP6906 Access and Login

I forgot the password.
The default password is on the device label.
1
If this does not work, you have to reset the device to its factory defaults. See
2
I cannot see or access the Login screen in the Web Configurator.
Make sure you are using the correct address.
1
• The default web address (URL) of the WAP6906 is http://zyxelsetup (for Windows) or http://
zyxelsetup.local (for Mac).
• The WAP6906's IP address is http://192.168.1.5.
Check the hardware connections, and make sure the LEDs are behaving as expected. See the Quick
2
Start Guide and
Make sure your Internet browser does not block pop-up windows and has JavaScript and Java
3
enabled.
Reset the device to its factory defaults, and try to access the WAP6906 with the default address.
4
If the problem continues, contact the network administrator or vendor, or try one of the advanced
5
suggestions.
Advanced Suggestions
• If your computer is connected wirelessly, use a computer that is connected to a LAN port.
I can see the Login screen, but I cannot log in to the WAP6906.
Make sure you have entered the password correctly. The default password is in the device label.
1
This can happen when you fail to log out properly from your last session. Try logging in again after 5
2
minutes.
Disconnect and re-connect the WAP6906.
3
If this does not work, you have to reset the device to its factory defaults. See
4
Chapter 11 Troubleshooting
Section 1.4 on page 11.
WAP6906 User's Guide
67
Section 11.4 on page 69.
Section 11.4 on page 69.