Using The Wps Button; The Reset Button; Using The Reset Button - ZyXEL Communications WAP6906 User Manual

WPS allows you to quickly set up a wireless network with strong security, without having to configure
security settings manually. Each WPS connection works between two devices. Both devices must
support WPS (check each device's documentation to make sure).
Depending on the devices you have, you can either press a button (recommended) on the device
itself, or in its configuration utility or enter a PIN (a unique Personal Identification Number that allows one
device to authenticate the other) in each of the two devices. When WPS is activated on a device, it has
two minutes to find another device that also has WPS activated. Then, the two devices connect and set
up a secure network by themselves.
The WPS button is located at the back panel of the WAP6906.

1.6.1 Using the WPS Button

Make sure the power LED is on (not blinking).
1
Uplink: Press the WPS button once. Press the WPS button on a WPS-aware AP or wireless router within
2
range of the WAP6906.
Downlink: Press the WPS button twice within three seconds. Press the WPS button on a WPS-aware client
within range of the WAP6906.
Note: You must activate WPS in the WAP6906 and in another wireless device within two
minutes of each other.
Note: With WPS, wireless clients can only connect to the 5GHz or 2.4GHz wireless network using
the first 5GHz or 2.4GHz SSID on the WAP6906.
For more information on using WPS, see

1.7 The RESET Button

If you forget your password or IP address, or you cannot access the Web Configurator, you will need to
use the RESET button at the back of the WAP6906 to reload the factory-default configuration file. This
means that you will lose all configurations that you had previously saved, the password will be reset to
the default key on the device label. The WAP6906 will be reset to obtain an IP address from a DHCP
server.

1.7.1 Using the RESET Button

Make sure the power LED is on (not blinking).
1
Press the RESET button for one to five seconds to reboot the WAP6906.
2
Press the RESET button for longer than five seconds to set the WAP6906 back to its factory-default
3
configurations.
Chapter 1 Introduction
Section 5.3 on page
WAP6906 User's Guide
14
30.