Advanced Wireless Network Screen; Wps Screen - ZyXEL Communications WAP6906 User Manual

8.5 Advanced Wireless Network Screen

Use this screen to select the advanced wireless settings for the WAP6906.
Click Networking > Wireless Network 2.4G > Advanced. The screen appears as shown.
Figure 25 Networking > Wireless Network 2.4G > Advanced
The following table describes the labels in this screen.
Table 15 Networking > Wireless Network 2.4G > Advanced
LABEL
Wireless Band
Channel
Bandwidth
Beacon Interval
DTIM Period
Short Guard
Interval
Apply
Cancel

8.6 WPS Screen

Use this screen to enable/disable WPS, view or generate a new PIN number and check current WPS
status. To open this screen, click Networking > Wireless Network 5G/2.4G > WPS.
Chapter 8 Wireless LAN
DESCRIPTION
Select the wireless standard you want to use for your wireless network.
Select the channel bandwidth you want to use for your wireless network.
Select whether the WAP6906 uses a wireless channel width of 20MHz or 40MHz. A standard
20MHz channel offers transfer speeds of up to 150Mbps whereas a 40MHz channel uses two
standard channels and offers speeds of up to 300 Mbps.
This is the time lag between each of the beacons sent by the wireless network.
The Delivery Traffic Indication Map (DTIM) period, is the moment the WAP6906 will broadcast
any buffered broadcast frames, after the WAP6906 broadcasts the beacon. Enter 1, and the
WAP6906 will transmit broadcast frames after every beacon, enter 2 and the WAP6906 will
transmit every other beacon.
Enable the Short Guard Interval to ensure the WAP6906 transmissions do not interfere with
each other.
Click Apply to save your changes to the WAP6906.
Click Cancel to reload the previous configuration for this screen.
WAP6906 User's Guide
51