Rear Panel - ZyXEL Communications WAP6906 User Manual

The following table describes the LED behavior.
Table 1 Front Panel LEDs
LED
Top LED
LAN Port LED
The timeline below helps you understand more about the WAP6906 LED behavior.

1.5 Rear Panel

The following figure is the rear panel of the WAP6906.
Chapter 1 Introduction
COLOR STATUS
White Blinking
Blue On
Blinking
Purple On
Blinking
Green On
Amber On
Blinking
Red On
Blinking
Off
Green On
Blinking
Off
WAP6906 User's Guide
DESCRIPTION
The WAP6906 is upgrading its firmware, rebooting or resetting.
The WAP6906 is receiving power and functioning properly, but the
wireless interface of the WAP6906 is not up or it has been up for more
than 5 minutes.
The WAP6906 is turning on.
The LED is on for 1 minute indicating the WPS process was successful.
The WAP6906 is negotiating a WPS connection with a wireless client.
The LED is on for 5 minutes indicating the wireless router or AP and
WAP6906 are connected, and the received signal strength is good.
The LED is on for 5 minutes indicating the wireless router or AP and
WAP6906 are connected, and the received signal strength is too
strong. This may cause interference with the wireless router or AP's
signal. Move the WAP6906 away from the wireless router or AP for a
larger range.
The LED is blinking for 1 minute indicating the WPS process failed.
The LED is on for 5 minutes indicating the wireless router or AP and
WAP6906 are connected, and the received signal strength is poor.
Move the WAP6906 closer to your wireless router or AP.
The WAP6906 lost its wireless connection to the AP. Find a new location
for the WAP6906 or press the WPS button to restart the WPS process.
The WAP6906 is not receiving power.
The WAP6906 has a successful 10/100/1000 Mbps Ethernet connection.
The WAP6906 is sending or receiving packets to/from an Ethernet
network on this port.
There is no connection on this port.
12