Mbss Screen - ZyXEL Communications WAP6906 User Manual

hexadecimal characters, for example, 00:A0:C5:00:00:02. You need to know the MAC address of the
devices to configure this screen.
To change your WAP6906's MAC filter settings, click Networking > Wireless Network 5G/2.4G > MAC
Filter. The screen appears as shown.
Figure 27 Networking > Wireless Network 5G/2.4G > MAC Filter
The following table describes the labels in this menu.
Table 17 Networking > Wireless Network 5G/2.4G > MAC Filter
LABEL
Interface
Policy
MAC Address
Apply
Remove
MAC filter list
Cancel

8.8 MBSS Screen

A Multiple Basic Server Set (MBSS) allows you to use your WAP6906 to provide several Basic Server Sets
(BSS) simultaneously. You can then assign varying security types to different SSIDs. Wireless clients can
use different SSIDs to associate with the same access point.
To open this screen, click Networking > Wireless Network 5G/2.4G > MBSS.
Chapter 8 Wireless LAN
DESCRIPTION
Select the SSID for which you want to configure MAC filtering.
Define the filter action for the list of specified MAC addresses.
Select None to deactivate the MAC filtering rule you configure below.
Select Allow to permit access to the WAP6906. MAC addresses not listed will be denied access to
the WAP6906.
Select Reject to block access to the WAP6906. MAC addresses not listed will be allowed to
access the WAP6906.
Enter the MAC addresses of the wireless station that are allowed or denied access to the
WAP6906 in these address fields. Enter the MAC addresses in a valid MAC address format, that is,
six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Click Apply if you want to add the MAC Address to the list.
Click Remove if you want to discard the MAC Address from the list.
This field shows the MAC addresses of the wireless station that are allowed or denied access to
the selected SSID.
Click Cancel to reload the previous configuration for this screen.
WAP6906 User's Guide
53