Selecting An Ap From An Automatically Detected List; Selecting An Ap By Manually Entering Security Information - ZyXEL Communications WAP6906 User Manual

5.4.1 Selecting an AP from an Automatically Detected List

Follow the steps below to create a secure wireless network by selecting an AP from a list of detected
APs. The instructions require that your hardware is connected (see the Quick Start Guide) and you are
logged into the Web Configurator through your LAN connection (see
Open the Networking > AP Connection > AP List screen. Select an AP form the SSID column. Type the
1
WiFi key if wireless security is enabled on the selected AP and click Connect.
Check the connection status to see if your WAP6906 is successfully connected to the AP.

5.4.2 Selecting an AP by Manually Entering Security Information

This example shows you how to configure wireless security settings with the following parameters on your
WAP6906.
SSID
Security
WiFi Key
Follow the steps below to create a secure wireless network by manually entering the AP's wireless
security settings in the WAP6906's interface.
The instructions require that your hardware is connected (see the Quick Start Guide) and you are
logged into the Web Configurator through your LAN connection (see
Chapter 5 Tutorials
Zyxel
WPA(2)-PSK
1234567890
WAP6906 User's Guide
34
Section 2.2 on page 15).
Section 2.2 on page 15).