Mac Filter - ZyXEL Communications WAP6906 User Manual

Note: With WPS, wireless clients can only connect to the 5GHz or 2.4GHz wireless network using
the first SSID on the WAP6906. This means you cannot connect to the SSIDs created in
the MBSS screen via WPS.
Figure 26 Networking > Wireless Network 5G/2.4G > WPS
The following table describes the labels in this screen.
Table 16 Networking > Wireless Network 5G/2.4G > WPS
LABEL
WPS Setup
State
WPS PBC
WPS PIN
Device PIN Enable
PIN Number
Apply
Cancel

8.7 MAC Filter

The MAC filter screen allows you to configure the WAP6906 to give exclusive access to devices (Allow)
or exclude devices from accessing the WAP6906 (Reject). Every Ethernet device has a unique MAC
(Media Access Control) address. The MAC address is assigned at the factory and consists of six pairs of
Chapter 8 Wireless LAN
DESCRIPTION
Select Configured to enable WPS and do NOT change the wireless security key after the WPS
connection is established.
Select Unconfigured to enable WPS but change the wireless security key after the WPS
connection is established.
Select Disabled to turn off WPS.
Click the Push Button to perform wireless security information synchronization using the Push
Button Configuration (PBC) Method.
Use this field to type the same PIN number generated in the wireless station's utility to perform
wireless security information synchronization using the PIN Configuration Method.
Click the WPS PIN button to establish the synchronization. The PIN should be between 4 and 8
characters.
Select this to allow the WAP6906 to create a new PIN number. Wireless clients then can use
the generated PIN number to perform wireless security information synchronization with the
WAP6906 via WPS.
This displays a PIN number last time system generated. Click Generate to generate a new PIN
number.
Click Apply to save your changes back to the WAP6906.
Click Cancel to get this screen information afresh.
WAP6906 User's Guide
52