Table of Contents
Advertisement
ETC Installation Guide
Occupancy Sensor
Verify Vacancy Operation
For systems that have been configured for the installed sensor to control
specific lighting circuits, walk test mode can also be used to verify vacancy
operation.
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Note:
Occupancy Sensor Installation Guide
Confirm the installing technician has programmed the lighting
control system.
Enable walk test mode using the instruction above (see
Walk Test
Mode).
With walk test mode enabled, exit the room for 15 seconds to
allow the 10 second timer to expire.
Re-enter the room and confirm the configured vacancy / no
occupancy state was properly recalled.
Walk test mode will automatically exit after five minutes from
the time it was enabled. To manually exit the walk test mode,
press either of the buttons on the sensor.
Small Room side view
0
8ft
2.4m
10ft
3.0m
12ft
3.7m
20ft
15ft
10ft
6.1m
4.6m
3.0m
Side view
0
8ft
2.4m
10ft
3.0m
12ft
3.7m
20ft
15ft
6.1m
4.6m
High Ceiling side view
0
20ft
6.1m
30ft
9.1m
40ft
12.2m
40ft
30ft
12.2m
9.1m
When in walk test mode, status LEDs will always behave as
indicated above, even if they have been programmed to be
off by the system configuration.
Page 8 of 8
5ft
0
1.5m
5ft
0
10ft
1.5m
3.0m
20ft
10ft
0
6.1m
3.0m
5ft
10ft
15ft
1.5m
3.0m
4.6m
5ft
10ft
1.5m
3.0m
10ft
20ft
30ft
40ft
12.2m
3.0m
6.1m
9.1m
Electronic Theatre Controls, Inc.
Enable
20ft
6.1m
20ft
15ft
4.6m
6.1m
Advertisement
Table of Contents
