Lexmark MS312 Service Manual page 89

Error code Description
200.38 Interpage servo gap smaller than expected for
galvo offset target evaluation.
200.42 Rogue sheet at ACM sensor while flushing the
paper path prior to declaring tray 1 source empty.
200.44 Page from tray 1 did not reach the input sensor (or
the manual feed sensor, if present) after multiple
pick attempts. Page did make it out of the tray at
least as far as the ACM sensor.
200.84 Image data did not start on time.
200.87 During warm up flush, sheet detected too long
over input sensor.
Sensor (input) static jam service check
Action
Step 1
Check the input sensor area for jammed media fragments.
Is the paper path free of partially fed or jammed media?
Step 2
Check the jam access cover if it is blocking the input sensor.
Is it blocking the input sensor?
Step 3
Check the input sensor cable for proper connection.
Is it properly connected?
Step 4
POR into the Diagnostics menu and perform a sensor test:
Diagnostics Menu > Base Sensor Test > Input.
Does the sensor state on the control panel display change when
it is toggled?
Step 5
Does the error remain?
Action
Go to
check" on page
Go to
check" on page
Go to
check" on page
Go to
on page
Go to
check" on page
Diagnostics and troubleshooting
89
"Sensor (input) early/late arriving service
90.
"Sensor (input) early/late arriving service
90.
"Sensor (input) early/late arriving service
90.
"Sensor (input) image jam service check"
91.
"Sensor (input) early/late arriving service
90.
Yes No
Go to step 2. Clear the paper path
of any media
fragments.
Replace the jam Go to step 3.
access cover. See
"Jam access cover
removal" on
page 243.
Go to step 4. Reseat the cable.
Go to step 5. Replace the input
sensor. See
sensor and input
sensor removal" on
page
Contact the next The problem is
level of support. solved.
4514-330
"Duplex
255.