Removal From The Din Rail - Advantech SmartMotion ST352 Hardware Manual

3. Router Design

3.7 Removal from the DIN rail

3.7 Removal from the DIN rail
The DIN rail clip is suitable for a DIN rail according to EN 60715 standard only. The default position of metal
rail clip, which is used for mounting the router on a DIN rail, is shown in the following figure. Its position can
be changed on some models (back or bottom). When changing the position of the DIN rail clip, tighten the
screws with max. 0.4 Nm torque.
Figure 10: Default position of metal DIN rail clip
To remove the router from the DIN rail, push the router down lightly, so the bottom part of the DIN rail clip
(hitched to the DIN rail) gets out of the rail and then pull out the bottom part of the router away from the DIN
rail.
Figure 11: Removal from the DIN rail
SmartMotion ST352 Hardware Manual 10