Removal From The Din Rail - Advantech SmartFlex SR304 Hardware Manual

3. Router Design

3.7 Removal from the DIN rail

3.7 Removal from the DIN rail

The DIN rail clip is suitable for a DIN rail according to EN 60715 standard only. The default position of
plastic or metal rail clip, which is used for mounting the router on a DIN rail, is shown in the following figure.
Its position can be changed on some models (back or bottom). When changing the position of the DIN rail
clip, tighten the screws with max. 0.4 Nm torque.
Figure 25: Default position of plastic and metal DIN rail clip
To remove the router from the DIN rail, push the router down lightly, so the bottom part of the DIN rail clip
(hitched to the DIN rail) gets out of the rail and then pull out the bottom part of the router away from the DIN
rail.
Figure 26: Removal from the DIN rail
SmartFlex SR304 Hardware Manual 13