Table of Contents
Advertisement
WARNING:
Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your
your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Procedure
1
Place the fan on the palm-rest assembly and align the screw holes on the fan with the screw holes on the keyboard shield.
2
Replace the two screws (M2x3) that secure the fan to the keyboard shield.
3
Connect the fan cable to the system board.
4
Route the I/O-board cables through the routing guides on the fan.
5
Slide the I/O-board cable into the connector on the system board and close the latch to secure the cable.
6
Adhere the tape that secures the I/O-board cable to the system board.
computer. After working inside your computer, follow the instructions in
Replacing the fan
After working inside
www.dell.com/
Replacing the fan
18
31
Advertisement
Table of Contents
