Table of Contents
Advertisement
WARNING:
Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your
your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
CAUTION:
Incorrect alignment of the heat sink can damage the system board and processor.
NOTE:
If either the system board or the heat sink is replaced, use the thermal pad provided in the kit to ensure that thermal
conductivity is achieved.
Procedure
1
Align the screw holes on the heat sink with the screw holes on the system board.
2
In sequential order (indicated on the heat-sink), tighten the seven captive screws that secure the heat sink to the system board.
NOTE:
The number of screws may vary depending on the configuration ordered.
Post-requisites
Replace the
base
cover.
28
Replacing the heat sink
computer. After working inside your computer, follow the instructions in
Replacing the heat sink
www.dell.com/
16
After working inside
Advertisement
Table of Contents
