Table of Contents
Advertisement
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Topics:
•
Procedure
•
Post-requisites
Procedure
1. Using the alignment posts, place the fan on the palm-rest assembly.
2. Align the screw holes on the fan with the screw holes on the keyboard shield.
3. Replace the two screws (M2x3) that secure the fan to the keyboard shield.
4. Connect the fan cable to the system board.
5. Route the I/O-board cables through the routing guides on the fan.
6. Slide the I/O-board cable into the connector on the system board and close the latch to secure the cable.
7. Adhere the tape that secures the I/O-board cable to the system board.
Post-requisites
Replace the
base
cover.
30
Replacing the fan
computer. After working inside your computer, follow the instructions in
Replacing the fan
18
After
www.dell.com/
Advertisement
Table of Contents
