WARNING:
Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your
your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Procedure
1
Connect the battery cable to the system board.
2
Align the tabs on the base cover with the slots on the palm-rest assembly and snap the base cover into place.
3
Replace the four screws (M2.5x5) that secure the base cover to the palm-rest assembly.
4
Tighten the six captive screws that secure the base cover to the palm-rest assembly.
Replacing the base cover
computer. After working inside your computer, follow the instructions in
After working inside
www.dell.com/
Replacing the base cover
4
13