Setting The Date And Time; Phone Programming - Rath VoIP Command Center Installation & Operation Manual

Setting the Date and Time

Step 9
All Distribution Module programming will be done from the Command Center handset
1. To enter Program Mode
a. Dial 1#91
b. Enter Password: 7284
2. To program the time zone
a. Dial 1002 followed by the appropriate time zone code
Eastern = 111
Central = 112
Mountain = 113
Pacific = 114
3. To program the date (month-day-year format)
a. Dial 1001 followed by the date
Example: 1001 02152011 for February 15, 2011
b. Touch the GREEN button in the middle of the phone when finished
4. To program the time (military time including hour-minute-second)
a. Dial 1003 followed by the time
Example: 1003 143000 for 2:30pm
5. To exit Program Mode dial 00 followed by the GREEN button

Phone Programming

Step 10
The VoIP Call Box is preprogrammed for Memory Location 1 to dial 3931 in order to call the Command
Center first.
Optionally, the VoIP Call Box can be programmed to dial an outside number if the call is not answered
at the Command Center. To do this, follow these instructions at the Command Center:
1. Press the speaker phone button
2. Dial 1, 3, 4
3. Dial 9, then the external number
4. Press #, *
5. To exit Program Mode dial 00 followed by the GREEN button
Step 11
Program the location message (optional)
1. Set the message frequency to option 3
2. In the message recording, state the location of the call box followed by "To begin two-way
communication press * "
Page 10