Setting The Date And Time; Emergency Phone Programming - Rath Command Center Installation & Operation Manual

Setting the Date and Time

Step 7:
Perform the following steps on the Command Center handset.
1. Enter Program Mode
a. Dial 1#91
b. Enter Password: 7284
2. Program Time Zone:
a. Dial 1002 followed by the appropriate time zone code:
Eastern Time Zone = 111
Central Time Zone = 112
Mountain Time Zone = 113
Pacific Time Zone = 114
b. Touch the GREEN button in the middle of the phone when finished
3. Program the Date (month-day-year format):
a. Dial 1001 followed by the date
Example: 1001 02152011 for February 15, 2011
b. Touch the GREEN button in the middle of the phone when finished
4. Program the time (military time including hour-minute-second):
a. Dial 1003 followed by the time
Example: 1003 143000 for 2:30pm
b. Touch the GREEN button in the middle of the phone when finished
5. To exit Program Mode dial 00 followed by the GREEN button

Emergency Phone Programming

Step 8:
The Phones are pre-programmed for Memory Location 1 to dial 3931 in order to call the Command Center first.
The Phone can be programmed to dial an outside number if the call is not answered at the Command Center (optional).
To do this, follow these instructions at the Command Center:
1. Press the speaker phone button
2. Dial 1, 3, 4
3. Dial 9, then the external number followed by #, * to store the number
4. Press the Speaker Phone button to hang up
Step 9:
Program the location message for the Phone (optional). Skip this step if a location message is not desired.
Option 1
2100 Series Phone
1. Follow the instructions that came with the Phone to set the message frequency to option 3.
2. Record your message.
a. At the end of the message add "For two-way communication, press * at any time".
Option 2
2400 Series Phone
1. Follow the instructions that came with the Phone to set the message frequency to option 3.
2. Record your message.
a. At the end of the message add "For two-way communication, press # four times after the beep".
Page 8