Software »Motion Manager« (Optional); Direct Drive Control - HNP Mikrosysteme mzr-2542 Operating Manual

9 Software »Motion Manager« (optional)
9 Software »Motion Manager« (optional)
The »Motion Manager« software enables operation and configuration of the
drive and offers a possibility of an online graphic analysis of the operating data.
The software is delivered on CD. The program may be installed on a PC running
under Windows 7
Install the software »Motion Manager« by starting the program »Setup« from
the CD.
If the CD are not available you may still download this program from the web
site http://www.hnp-mikrosysteme.de/download-center.html or the web site
www.faulhaber.com (menu support - download). Here, the latest version is
always available in English and German.
After the installation the »Motion Manager« program may be loaded from the
»Faulhaber Motors« folder from the Windows start menu.
In order to program the drive, the micro annular gear pump should be put into
operation. The drive should be connected to the PC with the delivered
null-modem cable.
9.1

Direct drive control

With software »Motion Manager« commands can be entered and sent directly
to the motion controller to change the settings of the controller or execute
movements.
figure 36 Motion Manager software for direct control of the drive
Last update: January 2016
®
, Windows 8 or Windows 8.1
Technical data subject to change without prior notice!
Operating manual mzr-2542 / mzr
®
operating systems.
-
2942
57