Siemens HIPATH 8000 User Manual page 183

Step by step
Call recording
A central voice recorder is installed in the network for
recording calls to which your telephone connects in
order to record the current voice traffic. The recorder
records the entire voice flow of two or more
participants.
You should configure a recording button in order to
simplify handling of manual call recording
is assumed in the description below that a
corresponding key has been configured.
Call recording modes
The service personnel can configure the following
operating modes for call recording:
• Manual
• AutoStart
• All Calls
• Disabled
The following settings are possible to audibly signal the
recording:
• Repeated
• Single Shot
• Off
Check with your service personnel as to which settings
were made for your phone.
Mode: ALL CALLS:
The telephone starts and stops the recorder
automatically in order to ensure that all calls are being
recorded.
Mode: MANUAL
You decide when the recorder is started and stopped or
paused. If the recorder is switched on, all further calls
will be recorded. If you pause the recorder then nothing
will be recorded. If there are no calls, then the recorder
likewise pauses.
Mode: AUTOSTART
The telephone starts the recorder automatically. You
can stop or pause the recorder yourself however and
restart it. If a call has already been recorded, new
Call recording
page 70. It
183