Installing Communicator In Panel - DSC 3G2080 Installation Manual

Installing Communicator with HS2016, HS2032, HS2064, and HS2128 Panel
NOTE: Before installing communicator or inserting/removing SIM, ensure that system power is OFF and telephone line is dis-
connected.
1. To assemble supplied mounting bracket, perform the following: (See Figure 1).
a. Remove the 4 white plastic standoffs from the bag provided with the communicator kit.
b. Insert the 4 standoffs through the back of the mounting bracket, into the holes at each corner. (The antenna mount-
ing tab should be facing away from you).
c. Place the bracket on a flat, solid surface. Hold the communicator component side up and orient the 4 holes on the
communicator with the 4 standoffs protruding from the bracket. Push the communicator firmly and evenly onto the
standoffs until it is securely attached to the mounting bracket.
d. Remove the panel front cover.
e. Remove and discard the circular knockout located in the top-right section of the panel. (This hole will be used for con-
nection of the supplied radio antenna).
f. Connect the supplied 5" (12.7 cm) antenna cable to the radio, by passing the connector through the hole on back of
the mounting bracket to the communicator board. Push the antenna connector firmly into the socket on the cellular
radio. (See Figure 3).
Brass Washer
Nylon washer (flat)
Nylon Washer
with bushing
(thicker flat washer)
Mounting Holes
Communicator
Board
Mounting
Plate
2. Install the Communicator into the panel:
a. Attach one end of the PC-LINK cable to the panel PCLINK_2 header on the panel (red wire goes on the right-hand
pin of the panel PCLINK_2 header (see Figure 3)).
b. Insert the assembled communicator into the panel.
NOTE: Ensure that the threaded antenna connection point is visible through the knockout hole at the top right of the
panel.
c. Place the nylon washer with bushing (thick flat washer) onto the threaded section of the antenna cable. Insert the
threaded section through the antenna mounting knockout hole at top right of panel.
d. Place the second nylon washer (flat), followed by the brass washer and the brass nut, onto the threaded section of
the cable, outside the panel. Tighten the assembly by hand only (finger tight only- do not over tighten the antenna
assembly).
e. Locate the screw hole on the right side wall of the panel. See Figure 2 "screw". Line up the assembled com-
municator with the right side wall of the panel and, using the screw provided, secure the mounting bracket to the
panel.
f. Attach the other end of the PC- LINK cable to the communicator (red wire goes on the right-hand pin of the com-
municator PC-LINK header (See Figure 3)).
g. Using light pressure (finger tight only), attach the supplied white quad band whip antenna to the threaded antenna
connection point at top of the panel.

Installing Communicator in Panel

Figure 1: Communicator Mounting Bracket
Stand Off
External Antenna
Screw Thread
Brass nut
Antenna
Mounting Tab
Antenna
Cable
Mounting Plate
6
Mounting
Holes