Removing And Installing The Disk Drive - Siemens SIMATIC PC 670 Equipment Manual

Maintaining and Extending the Computing Unit
4.5.3

Removing and installing the disk drive

1. Open the housing as described in Chapter 4.1.
2. Remove the drive mounting as described in section 4.5.1.
3. Undo the interlocking of the controller flexible cable on the motherboard and pull
the flexible cable out of the plug connection.
4. Undo the two fixing screws (TORX T8) on the housing.
5. Lift the floppy disk drive up and out of the housing.
6. Proceed in the reverse order to install the new drive. The new drive must be of
the same type as the one removed.
Floppy disk drive fixing screws
Figure 4-15
4-20
Assembly of the computing unit floppy disk drive
Panel PC 670 Computing Unit, Equipment Manual
Release 04/02