Error Message Appears On The Screen/Display - Siemens SIMATIC PC 670 Equipment Manual

Fault Diagnosis
6.7

Error Message Appears on the Screen/Display

Error messages
The error messages issued by the system BIOS are listed below. Refer to the
relevant program manuals in the case of error messages issued by the operating
system or programs.
Press F2 during the boot routine to call in the Setup menu (refer to Chapter 5).
Error message on screen
Address conflict
Combination not supported
IO device IRQ conflict
Invalid System Configuration
Data
Allocation Error for ...
System battery is dead
Replace and run SETUP
System CMOS checksum bad
Run SETUP
Incorrect Drive A type
Run SETUP
Incorrect Drive B type
Run SETUP
Diskette drive A error
Diskette drive B error
Failure Fixed Disk
Keyboard error
Stuck Key
System RAM Failed at offset:
Shadow RAM Failed at offset:
Extended RAM Failed at offset:
Failing Bits:
6-6
Significance/Advice
Plug and Play Problem
Contact your technical service department.
Plug and Play Problem
Contact your technical service department.
Plug and Play Problem
Contact your technical service department.
Plug and Play Problem
Set the RESET CONFIGURATION.DATA option in the Advanced
Setup menu.
Contact your technical service department.
Plug and Play Problem
Please revert the last hardware modification.
Contact your technical service department.
Battery on the CPU module is defect or empty.
Contact your technical service department.
Call in SETUP, define settings and store. If this message appears
during each boot routine, contact your technical service department.
Check the SETUP entries for drive A.
Check the SETUP entries for drive B.
Fault accessing drive A
Contact your technical service department.
Fault accessing drive B.
Contact your technical service department.
Fault accessing the hard disk.
Check the SETUP settings
Contact your technical service department.
Check that the keyboard is connected correctly.
Check whether a key on the keyboard is jammed.
Memory error
Contact your technical service department.
Memory error
Contact your technical service department.
Memory error
Contact your technical service department.
Memory error
Contact your technical service department.
Panel PC 670 Computing Unit, Equipment Manual
Release 04/02