An Error Message Is Displayed On The Screen - Siemens SIMATIC Panel PC 870 Equipment Manual

Fault Diagnosis
6.5

An error message is displayed on the screen

Error messages
All error messages output by the system BIOS are described below. For error
messages output by the operating system or by the program, please refer to the
manuals for the relevant programs.
To call the setup, press <F2> while the computer is booting.
Error message on the screen
Address conflict
Combination not supported
IO device IRQ conflict
Invalid System Configuration
Data
Allocation Error for ...
System battery is dead
Replace and run SETUP
System CMOS checksum bad
Run SETUP
Incorrect Drive A type
Run SETUP
Incorrect Drive B type
Run SETUP
Diskette drive A error
Diskette drive B error
Failure Fixed Disk
Keyboard error
Stuck Key
System RAM Failed at offset:
Shadow RAM Failed at offset:
Extended RAM Failed at offset:
6-4
Plug&play problem
Contact the technical customer service.
Plug&play problem
Contact the technical customer service.
Plug&play problem
Contact the technical customer service.
Plug&play problem
Please set the option RESET CONFIGURATION.DATA in the Setup
menu "Advanced".
Contact the technical customer service.
Plug&play problem
Please undo the last hardware change.
Contact the technical customer service.
The battery on the CPU module is defective or empty.
Change the battery as described in Section 4.3.
Call SETUP (see Section 5), make the appropriate settings and save
them. If this message always occurs whenever the PC boots, contact
the technical customer service.
Check the SETUP entries of drive A.
Check the SETUP entries of drive B.
Error accessing drive A
Contact the technical customer service.
Error accessing drive B
Contact the technical customer service.
Error accessing the hard disk
Check the SETUP settings.
Contact the technical customer service.
Check whether the keyboard is connected correctly.
Check whether a key of the keyboard is jammed.
Memory error
Contact the technical customer service.
Memory error
Contact the technical customer service.
Memory error
Contact the technical customer service.
Panel PC 870 Computing Unit Equipment Manual
Meaning/tip
Edition 12/01