Intended Use; Disclaimer; Environmental Aspects; Esd Protection - E+E Elektronik EE310 Operation Manual

warnings that must be observed by the user in order to ensure safe operation.
• Mounting, start-up, operation and maintenance of the device may be performed by qualified staff only.
• Such staff must be authorized by the plant operator to carry out the mentioned activities.
• The qualified staff must have read and understood this operating manual and must follow the instruc-
tions contained within.
• All process and electrical connections shall be thoroughly checked by authorized staff before putting
the system into operation.
• Do not install or start-up a device supposed to be faulty. Make sure that such devices are not acciden-
tally used by marking them clearly as faulty.
• A faulty device may only be investigated and possibly repaired by qualified, trained and authorized
staff. If the fault cannot be fixed, the device shall be removed from the system.
• Service operations other than described in this operating manual may only be performed by the
manufacturer.
1.2.5

Intended Use

EE310 is optimized for reliable measurement in demanding industrial applications. In addition to highly
accurate measurement of relative humidity (RH) and temperature (T), the transmitter also calculates
parameters such as dew point, absolute humidity and mixing ratio.
Various models are available including wall, duct and remote probe. The remote probe can be used up
to 180 °C (356 °F) and the pressure tight probe up to 20 bar (290 psi). The use of the EE310 other than
described in this manual is not allowed.
The manufacturer cannot be held responsible for damages as a result of incorrect handling, installation
and maintenance of the device.
Unauthorized modifications of the product lead to loss of all warranty claims. The device may only be
powered as decried in this manual.
1.2.6

Disclaimer

The manufacturer or his authorized agent can only be held liable in case of willful or gross negligence.
In any case, the scope of liability is limited to the corresponding amount of the order issued to the ma-
nufacturer. The manufacturer assumes no liability for damages incurred due to failure to comply with the
applicable regulations, operating instructions or the operating conditions. Consequential damages are
excluded from the liability.
1.3

Environmental aspects

Products from E+E Elektronik® are developed and manufactured observing of all relevant requirements
with respect to environment protection. Please observe local regulations for the device disposal.
For disposal, the individual components of the device must be separated according to local recycling
regulations. The electronics shall be disposed of correctly as electronics waste.
1.4

ESD Protection

The sensing elements and the electronics board are ESD (electrostatic discharge) sensitive compo-
nents of the device and must be handled as such. The failure to do so may damage the device by
electrostatic discharges when touching exposed sensitive components.
Operating instructions for EE310 Humidity / Temperature Transmitter
5