Transportation Safety Device; Figure 2-2. North American Electrical Socket - Beckman Coulter Allegra 25R Instruction Manual

TRANSPORTATION SAFETY DEVICE

Figure 2-2. North American Electrical Socket

• Make sure that the matching wall outlet receptacle is properly
wired and earth-grounded. Check that the line voltage agrees with
the voltage listed on the name rating plate affixed to the centrifuge.
• Never use a three-to-two wire plug adapter.
• Never use a two-wire extension cord or a two-wire non-grounding
type of multiple-outlet receptacle strip.
• If there is any question about voltage, have a qualified service
person measure it under load while the drive is operating.
To ensure safety the centrifuge should be wired to a remote emer-
gency switch (preferably outside the room where the centrifuge is
housed, or adjacent to the exit from that room), in order to disconnect
the centrifuge from the main power source in case of a malfunction.
The centrifuge is shipped with a transportation safety device
(368248) installed on the instrument bottom to prevent damage to
the drive motor during transit. When installation of the centrifuge is
complete, the Beckman Coulter Field Service representative will
remove the transport device. Save it to use during future relocation
of the centrifuge.
Preinstallation Requirements
X
G
Y
34.3
mm
2-3