Connections - KING One Pro KOP4800 Owner's Manual

NOTE: If you wish to roof mount the antenna, see the Installation Guide that came with your KING One Pro.
Make the connections on page 6 or page 7.
PAGE 6: Make these connections unless you have an H/HR25 or higher receiver.
PAGE 7: Make these connections if you have an H/HR25 or higher receiver.
(Requires DSWM30 Kit - sold separately)
NOTE: The KING One Pro will not receive channels broadcast from DIRECTV's Ka band satellites at 99° and 103°.
When using page 7 connection diagram, you will not receive programming from the 119 satellite.
Connect all coax cables first. Plug in power inserter and then receivers.
Power inserter is for indoor use only.
Place the power inserter in an accessible location.
Do not over-tighten the coax connections.
Do not put sharp bends or kinks in the cables.
Do not route the cables where they can be tripped on or run over by a vehicle.
After connecting and plugging in all components, wait for the power inserter
LED to start flashing orange (about 10 seconds).
Go to page 8.

CONNECTIONS

• • • • • IMPORTANT POINTS! • • • • •
HAND-TIGHTEN COAX.
OVER-TIGHTENING CAN
DAMAGE CONNECTIONS.
Page 5