Installing An Optical Fiber Cable - Zte ZXSDR R8854 Hardware Installation

When you make the connector of the DC power cable, cut off the exposed shielded
layer after stripping off the cable end and bind the connector with a heat shrink tube
or insulating tape.
13. Label the power cable at both ends.
– End of Steps –

5.6 Installing an Optical Fiber Cable

This procedure describes how to install an optical fiber cable.
Steps
Installing Optical Fiber
1. Open the crimping clip at the left side of the maintenance window, see
Figure 5-15 Open the crimping clip
2. Remove the cable tie at one end of the corrugated pipe marked as "RRU" by using the
diagonal pliers.
3. Remove the white dust cap of the optical cable connector, see
Figure 5-16 Remove the white dust cap
1. White dust cap
SJ-20160405141455-003|2018-01-03 (R1.3)
5-15
ZTE Proprietary and Confidential
Chapter 5 Cable Installation
Figure 5-15.
Figure 5-16.