Installing The Dc Power Input Cable - Zte ZXSDR R8854 Hardware Installation

ZXSDR R8854 Hardware Installation

5.5 Installing the DC Power Input Cable

This procedure describes how to install the
Context
The ZXSDR R8854 DC power connector supports power cables with the sectional area of
4 mm 2 or 6 mm
used because the distance between theZXSDR R8854 and an external power supply is
too long, a DC junction box (ODCPD1) is needed to connect the power cable to that with
the section area of 4 mm
refer to Chapter 9 Installing the DC Junction
Steps
Open the maintenance window
1. Open the maintenance window at the side of the ZXSDR R8854, see
Figure 5-8 Open the maintenance window
Making the Power Cable Connector
2. Follow the maintenance window diagram to tailor the naked shielding layer, child
cables, and naked copper cores. Sheathe the tailored cooper cores with tubular
terminals and use the crimping pliers to crimp these tubular terminals, see
SJ-20160405141455-003|2018-01-03 (R1.3)
2 . If the power cable with the sectional area of 10 mm
2 or 6 mm 2 . For how to install the DC junction box (ODCPD1),
5-10
DC power input cable.
Box.
ZTE Proprietary and Confidential
2 or 16 mm 2 must be
Figure 5-8.
Figure 5-9.