Unused Interface Protection - Zte ZXSDR R8854 Hardware Installation

ZXSDR R8854 Hardware Installation
9. Put the remaining waterproof plugs back to their original positions after installing all
power cables and fibers. Close the panel of maintenance window and install the
screws securely to avoid water penetration.
The screws must be fastened to prevent water intrusion.
– End of Steps –

5.7 Unused Interface Protection

After installing all cables, you need to protect all unused interfaces on the ZXSDR R8854.
Steps
1. Check an unused interface.
Check whether an unused interface is covered with a dustproof cap. If not, cover it
with a dustproof cap.
2. Waterproof a dustproof cap.
Wrap it with a black double-layer ultraviolet-proof tape: the first layer from top down,
the second layer from bottom up according to the direction of tightening the interface.
Make sure that the wrapped tape is flush with the lower surface of the cap. Tighten
the edge of the tape with a cable tie.
– End of Steps –
SJ-20160405141455-003|2018-01-03 (R1.3)
Caution!
5-18
ZTE Proprietary and Confidential