Zte ZXSDR R8854 Hardware Installation page 67

9. Use the crimping clip to crimp the naked part of the shielding layer, secure the power
cable at the original waterproof plug, and ensure that the naked part has a close contact
with the crimping clip.
The top edge of the power cable's black outer sheath shall align with the bottom edge
of the crimping clip and shall not be lower than the top edge of the card slot.
10. Wrap the power cable along the pole or cable try and use black ties to bundle and
secure it.
If the DC Junction Box (ODCPD1) is equipped, refer to
Junction
Earthing the Power Cable
11. Connect the power cable to the grounding busbar through a grounding kit based on
the location of the baseband cabinet connected to the other end of the power cable,
see Figure
If...
The baseband cabinet is
installed outdoors
The baseband cabinet is
installed indoors
SJ-20160405141455-003|2018-01-03 (R1.3)
Note:
Box.
5-13.
Then...
Connect the power cable to the outdoor grounding busbar through the
grounding kit before the cable is led into the cable inlet hole of the
outdoor cabinet.
Connect the power cable to the grounding busbar through the grounding
kit before the cable is led into the room and near the feeder window.
l Protect the grounding kit against water with the "1+3+3" solution if
the power cable is earthed before being led into the feeder window,
refer to
l
Wind the grounding kit with two layers of insulating tape if the
power cable is earthed after being led into the feeder window. The
grounding cable is connected to the outdoor grounding busbar.
Chapter 10 Waterproofing Outdoor
5-13
ZTE Proprietary and Confidential
Chapter 5 Cable Installation
Chapter 9 Installing the DC
Connectors.