Zte ZXSDR R8854 Hardware Installation page 65

Figure 5-9 Wire stripping the power cable
3. Pass the tubular terminal round the trimmed bare copper core and crimp the tubular
terminal with the crimping pliers.
4. Confirm the polarity of the power connector's socket connected to the power cable.
5. Use the screwdriver to press the mandrill until it cannot rebound and stuff the tubular
terminals into the crimping tube, see
of conductors be completely inserted and have a close contact with the inner bottom
of the connector's plug.
Figure 5-10 Insert the crimped tubular terminal
1. Button
2. Pull-tab insulator
Standard assembly requires that tubular terminals cannot be pushed forward any
more.
6. Press the red and blue buttons (you may use tools like screwdriver but are not allowed
to use heavy tools like hammer, or the plug may be managed). The mandrill ejects
automatically. If you pull the conductor with your hand but it does not fall down, it
indicates the conductor is installed securely.
Connecting Power Cable on the RRU
SJ-20160405141455-003|2018-01-03 (R1.3)
Note:
Figure 5-10. It is required that the leading ends
3. Mandrill
4. Crimping tube
5-11
ZTE Proprietary and Confidential
Chapter 5 Cable Installation
5. Shell