Installing Antenna Feeder Cables - Zte ZXSDR R8854 Hardware Installation

6. Bundle and label the cable.
7. Apply antirust paint around the grounding bolts on the grounding busbar.
– End of Steps –

5.2 Installing Antenna Feeder Cables

This procedure describes how to install an antenna feeder cable.
There are two types of antenna feeder cables, antenna feeders and jumpers. The distance
between the RRU and the antenna determines how to install an antenna feeder cable. For
details, refer to
Table 5-1 Antenna Feeder Cable Installation
If...
The distance between the base station and
the antenna is less than five meters
The distance between the base station and
the antenna is greater than five meters and
less than 20 meters
Steps
1. (Optional) Install a heat-shrink sleeve on the feeder connector if a feeder connector
needs to be made on site, see
Figure 5-3 Making a Feeder Connector
If the distance between the base station and the antenna is greater than five meters,
both feeders and jumpers are used for connection. In this case, feeder connectors
should be made on site.
2. Connect the feeder cable to the antenna feeder interface on the RRU chassis, see
Figure
SJ-20160405141455-003|2018-01-03 (R1.3)
Table 5-1.
Note:
5-4.
Then...
A feeder jumper is used.
A 1/2" feeder is used.
Figure 5-3.
5-5
ZTE Proprietary and Confidential
Chapter 5 Cable Installation