Table of Contents
Advertisement
NOTICE: If some preservative oil stays in the engine, it will not damage the engine. The
preservative oil will be removed after the first 25 hours of operation during the oil
change.
E. Remove, examine, clean, and reinstall the oil suction screen per the "Oil Suction Screen
Removal/Inspection/Cleaning/Installation" section in Chapter 12-10 of the TEO-540-A1A
Engine Maintenance Manual.
F. Apply one to two drops of Loctite
install the oil sump drain plugs in the oil sump. Torque the drain plugs in accordance with the
latest revision of the Service Table of Limits - SSP-1776.
CAUTION
G. Safety wire/cable the oil sump drain plugs in accordance with the standard practices per the
latest revision of AC43.13-1B or the latest revision of Service Instruction No. SI-1566.
12. Remove the oil filter and install a new oil filter. Refer to Chapter 12-10 in the TEO-540-A1A
Engine Maintenance Manual.
13. If the front expansion plug is installed and a constant speed propeller is to be used, remove the
expansion plug per instructions in the "Crankshaft Disassembly" section of Chapter 72-20 in the
TEO-540-A1A Engine Maintenance Manual.
14. Refer to Chapter 74-20 in the TEO-540-A1A Engine Maintenance Manual to:
A. Examine the spark plugs.
B. If spark plugs are acceptable, install them with a new gasket. If the spark plugs are dirty,
clean them per the procedure in Chapter 05-30 of the TEO-540-A1A Engine Maintenance
Manual. If the spark plugs are not acceptable, install new spark plugs with a new gasket.
C. Remove the protectors on the ignition lead ends.
D. Connect the ignition lead ends.
15. Remove the fuel inlet strainer and clean it with a hydrocarbon-based solvent such as mineral
spirits or equivalent.
16. Examine the fuel supply lines, fuel manifold, and throttle body to make sure they are clean and
dry.
17. Add ashless dispersant oil to a new, overhauled, or rebuilt engine. Record the amount of oil
added. Refer to Appendix A for the oil capacity. Refer to the "Add Oil" procedure in the "Engine
Installation" chapter in this manual.
18. Use the correct procedure for disposal of drained oil and fuel in accordance with local, state,
federal, and environmental protection regulations.
Requirements for Engine Installation
Page 30
®
564
MAKE SURE THAT THE OIL SUMP DRAIN PLUGS AND THE OIL
SUCTION SCREEN PLUG ARE TORQUED CORRECTLY AND ARE
SECURE. IF THE DRAIN PLUGS AND OIL SUCTION SCREEN PLUG
ARE NOT INSTALLED SECURELY, OIL CAN LEAK, WHICH
EVENTUALLY OVER TIME CAN CAUSE ENGINE FAILURE.
TEO-540-A1A Engine Installation and Operation Manual
™
to the threads of each oil sump drain plug and
© 2018 Avco Corporation. All Rights Reserved
October 2018
Advertisement
Table of Contents
