Table of Contents
Advertisement
TEO-540-A1A Engine Installation and Operation Manual
Step 3. Remove Components
It could be necessary to temporarily remove a component, such as an exhaust pipe, to install the
engine in its compartment on the aircraft.
Remove only the components necessary to enable engine installation.
The component(s) will be re-installed after the engine is installed.
Step 4. Install Engine Mounting Brackets
If not already done, install the four engine
mounting brackets on the engine. If the engine
mounting brackets were removed from a
previously installed engine, examine the
brackets per the "Engine Mount Inspection"
section in Chapter 72-00 of the TEO-540-A1A
Engine Maintenance Manual.
The engine is installed in the aircraft using the
rear top and bottom engine mounts. There are
no mounts in the front of the engine.
Figure 4
Engine Mounts
Requirements for Engine Installation
© 2018 Avco Corporation. All Rights Reserved
Page 32
October 2018
Advertisement
Table of Contents
