Enable Or Disable Operator Actions From The Display; Enable Or Disable The Acknowledge All Alerts Display Command - Emerson Micro Motion Configuration And Use Manual

Configure device options and preferences
2.
5.2 Enable or disable operator actions from the
display
You can configure the transmitter to let the operator perform specific actions using the
display.
•
5.2.1 Enable or disable the Acknowledge All Alerts display
command
Display
ProLink III
Field Communicator Configure > Manual Setup > Display > Display Menus > Acknowledge All
Overview
You can configure whether or not the operator can use a single command to acknowledge
all alerts from the display.
Procedure
1.
2.
70
Option Description
Disabled (de- The display shows Display Variable 1 and does not scroll automatically. The
fault) operator can move to the next display variable at any time using Scroll.
If you enabled Auto Scroll, set Scroll Rate as desired.
The default value is 10 seconds.
Tip
Scroll Rate may not be available until you apply Auto Scroll.

Enable or disable the Acknowledge All Alerts display command

OFF-LINE MAINT > OFF-LINE CONFG > DISPLAY > ACK
Device Tools > Configuration > Transmitter Display > Ack All
Ensure that the alert menu is accessible from the display.
To acknowledge alerts from the display, operators must have access to the alert
menu.
Enable or disable Acknowledge All Alerts as desired.
Option Description
Enabled (default) Operators can use a single display command to acknowledge all alerts at
once.
(Section 5.2.1)
Micro Motion ® Fork Density Meters (FDM)