Siemens SINAUT MD740-1 User Manual page 58

Configuration
58 von 105
Start DHCP Server
Set this switch to Yes if you want to enable this function.
Enable dynamic IP address pool
Set this switch to Yes if you want to use the IP address pool
selected by DHCP range start and DHCP range end.
Set this switch to No if only static assignments based on the
MAC address are to be performed (see below).
Options:
If the DHCP server and the dynamic IP address pool are
enabled you can indicate the network parameters to be used by
the client
DHCP range start:
DHCP range end:
Local netmask:
Default gateway:
DNS server:
Client MAC address / client IP address
You can establish the MAC address of your client as follows:
Windows 95/98/ME: Start "winipcfg" in a DOS box
Windows NT/2000/XP: Start "ipconfig /all" in a prompt. The
MAC address is displayed as a "physical address".
Linux: Call up "/sbin/ifconfig" or "ip link show" in a shell .
Delete address
Click on Delete next to the entry concerned, then OK or Apply.
Add address
If you want to add a new address, click on New.
Enter the address data (see below) and click on OK or Apply.
Enter:
Client MAC address
The MAC address (without spaces or hyphens) of the client.
Start and end of the address range from
which the DHCP server of the
SINAUT MD740-1 is to assign IP
addresses to the locally connected
clients.
Default setting: 255.255.255.0
Determines which IP address is to be
used as the default gateway by the
client. This is usually the local IP
address of the
SINAUT MD740-1.
Determines from where clients receive
resolution of hostnames in IP addresses.
If the DNS services of the SINAUT
MD740-1 is enabled it can be the local
IP address of the SINAUT MD740-1.
SINAUT MD740-1