Putting The Device Into Operation; Connecting The Device - Siemens SINAUT MD740-1 User Manual

Putting the device into operation

3 Putting the device into operation
To put the device into operation, perform the following steps in the order given:
1.
Connect the device
2. Configure the PIN
3. Insert or change the SIM card
4.
Perform further configuration
!
First tell the device the PIN of the SIM card. Then insert the SIM card.
!
The device also supports SIM cards without a PIN. If your SIM card has no PIN you
can also insert the SIM card before performing configuration.
!
The device must be switched off when you insert or remove the SIM card.
3.1

Connecting the device

Current supply: The screw terminals on top of the device for connecting of the current
supply: 24 V DC voltage (nominal), max. 600mA
+ 24 V
+ 24 V
0 V
0 V
Both terminal screws to the left (24 V)
are connected.
Both terminal screws to the right (0 V)
are connected.
Service interface.
Optional:
For the connection of a PC to display
device, status and connection
information.
To connect, use a V.24 cable.
Digital gate input
12 von 105
I1+
I1-
Antenna
(approx
. 50 Ohm
Application interface.
Connect the
application device
here.
When connecting to
the network card of a
computer use a cross-
over Ethernet cable.
When connecting to
the network use a
UTP cable (CAT 5).
Digital gate output
O1a
O1b
SINAUT MD740-1
Page
12
14
15
19
)