Step 3 - Testing And Getting To Know Your Monitor - Angelcare AC300 Owner's Manual

STEP 3 - TESTING AND GETTING TO KNOW YOUR MONITOR

Test monitor when moving Sensor Pad to a new location to ensure sensitivity
is adjusted correctly to the new padding or mattress.
3.1 - SENSOR PAD
TO TEST SENSOR PAD:
1
3
IF THE ALARM DOES NOT SOUND
• Avoid contact with crib
while Sensor Pad is in operation.
• Place crib near a supporting wall.
• Adjust Sensor Pad sensitivity level.
TO STOP THE ALARM
Place your hand
back on the
mattress.
2
4
OR
1) Turn ON Power/'TIC' switch
2) Move your hand lightly on the mattress.
3) Remove your hand from the mattress.
After 15 seconds you will hear a 'TIC'
pre-alarm sound.
4) 5 seconds later the alarm will sound and
the red light (Alarm Indicator) will flash
continuously.
MOVEMENT ALARM
• If NO movement is detected after
15 seconds you will hear a single 'TIC'
pre-alarm sound from the Nursery Unit.
• If after a further 5 seconds there is still
NO movement detected, Nursery Unit
speakers will emit a loud warning sound.
E
N
Shut the Nursery
Unit OFF
11