Wrap Up Checklist - Culligan CSM Series Installation, Operating And Service Instructions

Wrap Up Checklist

Once you have completed the installation the system is ready to be placed in service. Prior to placing the system in ser-
vice review the following checklist to be sure the system is properly installed.
Check List
‰ The media tank(s) has been properly loaded with gravel and media.
‰ Retighten the nuts on all hand-hole covers, if applicable. The drain line has been properly installed.
‰ All option kits have been properly installed.
‰ The system has been properly piped and tubed.
‰ Air has been bled from the MVP controller pilot valve tubing and the system has been properly pressurized.
‰ Each media tank has been backwashed manually.
‰ The MVP controller(s) have been correctly and completely wired, including differential pressure switches if
equipped.
‰ All MVP controllers have been properly programmed and are active (power on).
‰ All manual isolation valves are open and system by-pass valves are closed.
‰ Clean up the unit and the installation site, removing any soldering or pipe threading residues from the equipment
with a damp towel.
‰ For units with steel tanks, place the Culligan label (packed with the media tank) on the front of the tank.
‰ Explain the operation of the system and the Suggested Preventative Maintenance Inspection Schedule
49) to the customer.
46 Culligan® CSM Series Filters
(page
46 Cat. No. 01016449