Tubing Installation - Culligan CSM Series Installation, Operating And Service Instructions

Tubing Installation

The tubing assembly is shipped in the same carton as the controller. The tubing is suppled in lengths pre-cut to connect
up to a 3" Brunermatic valve.
1. Using the tubing supplied, interconnect the controller, Brunermatic valve, and any accessory kits ordered with
the system. Refer to
2. For ease of installation, some tube fittings on the system are the push-in type. Tubing is simply inserted into the
fitting collet to make a secure, leak free connection. Refer to Figure 29 and Figure 30 for details on proper con-
nection and disconnection.
CONNECTION
To make a connection, simply push the tubing in by hand.
NOTE The fitting will grip before it seals. Make certain
the tubing is fully pushed into the tube stop.
TUBE STOP
Figure 29.
20 Culligan® CSM Series Filters
Figure 28.
Figure 31, Figure 32, and Figure 33
O -RING
C O LLET
for system tubing diagrams.
DISCONNECTION
To disconnect tubing, push in the collet against the face
of the fitting. With the collet held against the face of the
fitting, the tubing can be removed.
Figure 30.
20 Cat. No. 01016449