Table of Contents
Advertisement
4.9
After starting the engine (see section 5) run the chain at medium speed and see if
the chain oil has scattered off as shown in the image below.
6. STARTING PROCEDURE
NOTE
This machine is shipped without fuel/oil mix. Therefore you MUST fill the engine with
the correct fuel/oil mix before operation.
Failure to do so will result in engine damage which will not be covered by warranty.
Fill with a 40:1 ratio of semi-synthetic 2 stroke oil and fresh unleaded petrol.
See section 5 for further information.
FROM COLD
5.0
Fill the fuel tank (1) with the correct 40:1 mix of unleaded petrol and semi-synthetic 2
stroke engine oil.
5.1
DO NOT overfill, leave a 25mm gap at the top of the fuel tank.
(1) Fuel Tank
5.2
Rest the machine on flat, lever ground.
Keep the cutting head off the ground and clear of surrounding objects as it will start
rotating on start up.
17
Hide quick links:
Advertisement
Table of Contents
