Table of Contents
Advertisement
8.37
Make sure every cutter has the same length and edge angles as illustrated below.
1. Cutter length
CLEANING
CAUTION
DO NOT use a pressure washer or hose pipe to clean the machine.
Water could penetrate the engine and cause irreversible damage.
DO NOT use solvent based cleaning products on plastic parts.
6.26
Clean the machine and its accessories thoroughly after every use.
6.27
Clean moveable parts on a regular basis.
6.28
Keep the handles free of oil and grease.
6.29
Make sure that the ventilation slots for engine cooling are free from debris.
6.30
Keep the engine cooling fins free from dust and dirt.
10. STORAGE
WARNING
Storing the machine correctly will prevent possible starting issues or damage.
7.0
Perform all the general maintenance procedures specified in this manual.
7.1
Clean the outside of the machine.
7.2
Remove all of the fuel from the fuel tank.
7.3
After the fuel has been removed, start the engine and allow it to run at idle until the
engine stops to remove all the fuel from the carburetor.
7.4
Allow the engine to cool down.
7.5
Remove the spark plug and pour 1 teaspoon of clean fresh 2 stroke engine oil into
the combustion chamber.
7.6
Slowly pull the starter rope several times to allow the oil to coat internal components.
7.7
Replace the spark plug.
7.8
Store the machine in a cool, dry place away from any source of ignition.
(1)
2.Filing angle.
(2)
(3)
3. Side plate angle 4. Top plate cutting angle.
34
(4)
Hide quick links:
Advertisement
Table of Contents
